Knowledgebase: Product Questions
What's the difference between the Bemer 3000 and the Bemer 3000 Plus?
Posted by Jorah Lafleur on 19 November 2008 03:06 PM
The "Bemer Plus Signal" was introduced in 2007 after research showed that a very short duration but higher intensity pulse when delivered a few times per minute would speed up the end result of Bemer therapy.

What was found is that this additional impulse wouldn't change the overall result but the result would be achieved quicker.

This was integrated into the newer "Bemer Plus" units when running the P1, P2, P3 and P4 programs. The Plus signal does not run when using the Intensity levels 1 through 10, but only with the "P" programs.
(276 vote(s))
This article was helpful
This article was not helpful

Comments (0)
Post a new comment
Full Name:
CAPTCHA Verification 
Please enter the text you see in the image into the textbox below. This is required to prevent automated registrations and form submissions.

Help Desk Software by Kayako fusion